1/10/2024 0 Comments Repetier server needs ipupdate the packages installed on the system: apt-get upgrade To update your installation sources and package information, run: apt-get updateĪfter the completes, go ahead and let the C.H.I.P. If you are using one of the desktop firmware version, you will need to preface these commands with “sudo” and provide the “chip” when the system asks for a password. If you logged in as root, you can follow the commands below directly. via SSH over wireless (use the same putty application you used to set up the network), it is time to perform some updates. Once you’ve connected to your network and can connect to your C.H.I.P. it takes a few seconds for the computer to boot up and be available via the COM port. Just remember to be patient after plugging in your C.H.I.P. There are some excellent directions here: on doing just that. so it would connect to my wireless network. Updating C.H.I.P.Īfter flashing, I needed to set up my C.H.I.P. You might want a different image if you intend to make the repetier server a side-job for your C.H.I.P. I choose the “Headless Kernel 4.4” image since I was going to set this up as a server without a monitor and keyboard. all ready for flashing:Īfter that is done, head over to and follow the wizard to flash your device. This is a bit of an odd step, as you will need to unfold a paperclip and plug it into a couple of the pins on your C.H.I.P. In order to perform a flash, you will need to put your C.H.I.P. As it turns out, in the 4.4 firmware at least, it is! to get the latest and greatest image for the device and hope this was resolved. I also hadn’t used the device in quite a while, so I figured it was a good idea to reflash my C.H.I.P. Apparently, /dev/ttyUSB0 should have been a choice, and it wasn’t there. firmware didn’t include the USB Serial drivers in the kernel. After some searching around (most of the stuff out there is for the Raspberry Pi, which is a very similar device) it seems like the first builds of the C.H.I.P. It wasn’t connecting to the printer, and when I installed Repetier-Server it couldn’t find the printer. right after I got it so I could use the VGA adapter I got with it, but when I tried to set it up (monitor, keyboard, and all) connected to the 3D printer, I ran into some issues. Besides the instructions themselves, another major intent of this article is just to say that yes, it works, and it doesn’t require a lot of convoluted process to set up. pretty much the only thing I found was “it should” and some references to running it on the Raspberry Pi. When I went looking to see if Repetier-Server would run on the C.H.I.P. If you are an experienced Linux user, this is a very straightforward process. I had been using Repetier-Host on my PC with its embedded Repetier-Server, so I really wanted to keep using the software as it was my favorite of the 3D printing apps I’ve tried so far. kickstarter a while back, and had a $9 computer I had played with for a while and then not gone back to, so it seemed like a great opportunity to put it to use. My wife got me a 3D Printer (the MonoPrice Maker Select V2) for Christmas, and while I initially had it connected directly to my PC, when I rearranged things it was no longer close enough to be practical to connect with a USB cable.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |